Floor and Roof Framings

The structure parameters of horizontal structures are defined for each layer separately using a framing tool. The framing tool determines the design rules based on which the parts are added to the layer (joists to basic layer, other joists, sheets). The parts can be added to the entire structure, or to each layer separately.

Edit the Framing Tools of More than One Structure
Edit the Framing Tool of a Layer
Add Parts

You can edit the framing using the Edit framing properties, Edit origin points and Add cut line functions, for example. Regenerate parts after editing.

• Editing Framing Properties
• Adding And Refreshing Framing
• Deleting Framing
• Editing Framing Fields
• Managing Edge Details
• Editing Framing Lines
• Duplicating a Joist
• Selecting Beams in an Area
• Interference Check
• Adding a Primary Beam
• Adding And Removing a Section View
• Part List
• Framing Accessories
• Automatic Details
• Selecting Details for Floor or Roof Panels
• Table Designing of Floor Joists
• Adding a Single Joist
• Insulation
• Sheathing
• Boarding and Cladding

Note

• You can create beam structure panels of the pieces in a framing. You can use the Floor And Roof Panel functions for managing the beam structure panels.
• As a default, joints are formed between the parts of the framing when creating the framing. If necessary, you can create the framing without joints by setting the keyword framing_joint_mode= 0 in the keyword group BDSXX.

Beam Structures
Floor and Roof Panels
Editing Keywords