|
Framer, Floor Framing &
Rafters
|
Adding and removing section view
This function can be used to add a section view of a framing to
a 2D drawing. After adding the section view, you can remove it or
another section view added previously by clicking the section view.
You can select the section views to be removed before quitting the
function or adding a new section view.
- Select Floor Joists, Roof Rafters >
Section Drawing.
- Select the method of selecting the structural layer, and select
the structure and if necessary, the structural layer (type
FRAMING).
Selecting structural
layer
The cursor will turn into a horizontal line
from the left edge to the right edge of the drawing
window.
- If necessary, change the direction of the section by using the
DIR function.
- Select the section point. The cursor will be locked in the
direction perpendicular to the direction of the section.
- Select the location of the section view. The reference point of
the section view is located in the center of the framing in the
direction of thickness.
- Select the section view to be removed, if necessary.
Floor
Joists, Roof Rafters