|
Framer, Floor Framing &
Rafters
|
Interference check
This function can be used to find the points where the framing
pieces cross each other or are partially overlapped. You can select
the framings to be checked or you can check all the framings in the
active drawing-model pair.
- Select Floor Joists, Roof Rafters >
Interference Check.
- Select either of the following in the message box:
- Yes - When you want to check all the framings in the
drawing-model pair.
- No - When you want to select the framings to be checked.
- Select the method of selecting the structural layer from the
contextual toolbar.
Selecting structural
layer
- Select the structure and if necessary, the structural layer
(type FRAMING).
- Select the Confirm function.
The program displays a message box that shows the number of
points where the framing pieces cross or meet each other, and marks
the crossing points in the 2D drawing. Parallel contacts mean
framing pieces that are parallel and partially or entirely
overlapped. Crossing and meeting framing pieces are marked with
different symbols.
- Select either of the following in the message box:
- Remove - When you want to remove the intersect
markings.
- Ignore - When you do not want to remove the intersect
markings. You can remove them later by reselecting the interference
check function.
Floor
Joists, Roof Rafters