Dimensioning (2D)

Dimensioning

Dimensioning functions can be used to dimension a parallel projection.

For example, the axonometric projection of a model is dimensioned in the editing mode.

Base dimensioning can be used to dimension the distance between two points in a parallel projection.

Selecting the element to be dimensioned

Line
Start point and end point of the dimension
Line and point
Two lines
Arc or circle
Point and arc of the circle
Two arcs

Associativity of the Dimension to an Element

The dimension is an associative element that you select when adding a dimension.

If you delete the element, the associativity of the element is lost.

Dimensioning

Dimensioning of a Drawing

There are three different dimensioning directions to dimension slanting lines: direction of the line, direction of the Y axis and direction of the X axis. The dimensioning direction is determined by the movement of the cursor before the position of the dimension has been selected.

There are two alternatives to diameter dimensions, depending on the position of the cursor before the position of the dimension has been selected.

Dimensioning can also be carried out as inch dimensioning.

Dimension as a Geometric Constraint

A dimension can act as a geometric constraint, if 2D Constraint Manager is enabled.

A drawing's dimensions added using the dimensioning function are updated when changes are made to geometry.

Vertex G4: They act as constraints in the drawing, if the Dimensioning tools make constraints check box has been selected on the Others tab of the Dimensions> Settings dialog box. The requirement is that the dimensioned element is one of the following: line, dimension start and end points, line and a point, or two lines.

Miscellaneous Dimensioning Settings

Dimensions added to intersections or center points of lines are not updated when the geometry changes, and cannot act as constraints. Dimensions added with the Flattened forms function and Set dimensions for flattened forms function cannot act as geometric constraints.