Continuous Baseline Dimensioning
Start baseline dimensioning by selecting the start and end
points and the position of the first dimension by clicking on the
projection. After this, you need only select the end points for the
following dimensions.
You can perform chained linear dimensioning as follows:
- Select Dimensions> Continuous
baseline.
- Select the dimension properties.
- Select the start point (A) for the dimension.
- Select the end point (B) for the dimension.
- Select the position of the first dimension (C).
- Do one of the following:
- Continue baseline dimensioning by clicking another end point
(D).
- Accept the dimensioning by clicking with the middle mouse
button.
Note
- You can select
Parallel to Line Direction or
Perpendicular to Line Direction as the dimensioning
direction when adding the first dimension. Other dimensions are
added in the same direction. If the direction of the line defining
the dimensioning direction changes after the dimensions have been
added, the direction of the dimension does not change, however. The
dimension retains its original direction.
- If you want to move several parallel dimensions at once, select
the dimensions and select the Move function from the
context-sensitive menu.
- A zero is displayed by default at the start point of a chained
linear dimension. If necessary, you can disable it with the
Dimensions> Settings.
Dimension
Properties
Selecting Additional Dimension
Properties
Defining Properties after Adding the
Dimension
Auxiliary Dimensioning
Functions