Add a Component to the Center Line of a Pipe/Duct

By default, a component will be positioned in the direction of the pipe's/duct's center line when you lock the component to a pipe/duct.

1. Do either of the following:
   • Select Pipings > Add pipe component.
   • Select Pipings > Add duct component.

   The browser is opened.

2. Select a component.
3. Select properties for the component:
   • Select properties in the fields of the contextual toolbar.
   • If editing the component in a dimension table is allowed, select the Dimension table function and edit the properties.

   Pipe or Duct Component Properties
   Dimension Table

4. Before locking the component to the pipe/duct center line, you can rotate the component using auxiliary functions.

   Rotate a Component around the X, Y and Z Axis
   Enter Rotation Angles around the Z, Y and X Axes

5. When adding a component in a model, use snap functions:
   • Snap to line and point

     

   • Snap to all geometry

     

6. Click the center line of a pipe/duct. The component is locked on the center line. You can still move the component along the pipe/duct.
7. Before clicking a location for the component, you can rotate or mirror the component, or change its locating point. If necessary, rotate the component in the model Activate the model window by pressing the F2 key. Return to the drawing window by pressing the F2 key again.
   • Rotate the component

     Rotate to the Left or Right by a Single Rotation Step
     Enter the Rotation Angle around the Z Axis
     Indicate the Rotation Angle around the Z Axis in a Model
     Restore Original Position

   • Mirror the component

     If necessary, mirror the component before selecting its position. Click the button:

     

     

   • Change the reference point

     The default locating point is the component's grip point. If necessary, you can click a new point relative to which you position the component. Click the button:

     

8. Indicate the component position on the center line of the pipe/duct.

Note

• You can also set the pipe component on the side of the pipe by pressing the Alt key and clicking the center line of the pipe in the model.

Add a Pipe or Duct Component to a Grip Point
Add a Component while Adding a Pipe or Duct Line
Change a Pipe or Duct Component