Continue a Line from a Component

Continue routing a pipe or duct line by clicking the grip point at the end of the component.

1. Do either of the following:
   • Select Pipings > Add Pipe Line.
   • Select Pipings > Add Duct Line.
2. Click the grip point of the component.

   

   The direction determined by the grip point is automatically selected as the sweep direction. The cursor is locked in this direction, and you can click the subsequent point.

3. Proceed by clicking the next point of the pipe line.

Continue a Line from the End of a Pipe/Component
Continue a Line with a Branch Component
Continue a Pipe Line with a Set-on