Column End Drilling + Screw Leg

You can connect a column end to a log wall using an end drilling and screw leg joint. The joint adds machining to the column. The joint is also displayed in the log work drawing. If you remove or add logs above or below the column, the joint will follow.

1. Activate the model window.
2. Select Beams, Columns > Connection Details. The browser opens.
3. Select the Log Walls folder in the browser.
4. Select the 0004 Column end drilling + screw leg joint.
5. Select a log wall.
6. Select the ends of the columns to be connected.
7. Select Confirm. The Column Screw Leg Joint dialog box will open.
8. Define the joint parameters in the dialog box.
   • Drilling length - Select the drilling length (L) from the list or enter the desired value in the text field.

     

   • Drilling diameter - Select the drilling diameter (D) from the list or enter the desired value in the text field.

     

   • Settling space - Select the settling space (A) from the list or enter the desired value in the text field.

     

   Confirm by clicking OK.

9. If you have created a joint between the column and the wall earlier, delete the old joint by selecting Delete in the message box.

Note

• The joint is also displayed in the log work drawing.
• You can remove a joint in the following ways:
  • Select the red dashed line describing the joint in the wire frame model and press the Delete key.

    

  • Select Beams, Columns > Connections > Disconnect Profiles. Select the column and the Confirm function.
• When you add a log column, the program adds the settling space and screw leg to the top or bottom of the column according to your selection. After creating the joint, delete the screw leg macro from the log work drawing.

Adding a Log Column
Column End Tenon Joint
Vertex Browser