Setting Wall Stud Positions

Set the wall-specific first stud as follows:

1. Do either of the following:
   • Select Wall Panels > Panel Settings > Set Wall 1st Stud, when you are panelizing walls using the method based on the model.
   • Select Classic Wall Panels > Panel Settings > Set Wall 1st Stud, when you are panelizing walls using the method based on the panel drawings.
2. Click the starting point of the studding. The macro needs to be placed on top of the framing, but not necessarily at the center of the framing. The studs will be distributed from the starting point to both directions according to the stud spacing.

Setting Panel Stud Positions - Wall Panels Based on a Model
Setting Panel Stud Positions - Wall Panels Based on a Panel Drawing
Setting Global Stud Positions
Copying Stud Positions to Another Floor
Setting Stud Positions