Setting Stud Positions

The positioning of studs for a wall panel is defined in the project parameters or the wall frame parameters. The parameters determine the start point of positioning the studs, the stud spacing and the distance of the starting point from the end of the framing. The studs will be distributed from the starting point to both directions according to the stud spacing. You can override the stud starting point defined in the parameters by adding a macro, which determines the starting point, to the floor plan. The macro can be:

• Global - Determines the starting point for all parallel walls in the selected area. The global macro can be used to facilitate the positioning of the framing structures of walls and the floor.

  Setting Global Stud Positions

• Wall-specific - Determines the starting point for a specific wall. A wall-specific macro has dominance over the global macro.

  Setting Wall Stud Positions

• Panel-specific - If the wall consists of more than one panel, you can set the starting point panel-specifically.

  Setting Panel Stud Positions - Wall Panels Based on a Model
  Setting Panel Stud Positions - Wall Panels Based on a Panel Drawing

Copying Stud Positions to Another Floor
Wall Panels in a Framing Model
Classic Wall Panels