|
Framer, Floor Framing &
Rafters
|
Adding an origin point
This function can be used to add an origin point to a framing
field. One field may contain several origin points. The origin
points determine where the placing of the joists is started. A
joist is always positioned at the origin point.
Add an origin point to a framing field as follows:
- Select Floor Joists, Roof Rafters >
Edit Framing Fields.
- Select the method of selecting the structural layer, and select
the structure and if necessary, the structural layer (type
FRAMING).
Selecting structural
layer
- Right-click to open the context-sensitive menu.
- Select Add Origin.
- If necessary, change the direction of the origin point as
follows:
- Right-click to open the context-sensitive menu.
- Select one of the following:
- Vertical
- Horizontal
- Default (direction of the riser on a sloping plane)
- Select the direction
- Select the start point of the direction line.
- Select the end point of the direction line.
- Select a location for the origin point. You can locate the
origin at a distance of 600 mm or 1200 mm from the edge of the
framing field as follows:
- Move the cursor near the edge.
- Right-click to open the context-sensitive menu.
- Select either of the following:
- Distance 600
- Distance 1200
Note
- Before selecting a location for the origin point, you can
change its direction to horizontal or vertical also by using the
cursor keys Arrow right or Arrow left.
- After selecting the origin points and properties, you can
refresh the framing using the Add and
refresh framing function.
Editing framing
fields
Selecting a point
location