Adding a Staggered Cladding
When you are adding a cladding,
select the properties of a staggered cladding as follows:
- Select the properties of the staggered cladding in the
Staggered Cladding Selection dialog box.
Staggered Cladding Selection dialog
box
- Select the area where the cladding is added. Select the area by
clicking two corner points. The outline of the siding is drawn on
the layer 12 in the panel drawing. You can first make the
layer visible by using the function
Layers > Select Layers from List, and then
select the corner points of the cladding area by snapping the
corner points of the siding.
- Edit the cladding to fit the length of the wall in the Cladding
Fitting to Area dialog box.
Cladding Fitting to Area Dialog Box
- If you selected the layer 12 to be visible and hid all the
other layers, select the layer group of the panel drawing visible.
In the basic software delivery, the layer group name is Wall
Panels. Alternatively, you can change all layers visible by
using the function Layers > All
Layers.
- Close and save the panel drawing.
Adding
Cladding to a Panel Drawing
Saving a Panel
Drawing