Cladding Fitting to Area
Edit the cladding to fit the length of the wall in the Cladding
Fitting to Area dialog box.
The dimension in the field Cladding shortage informs how
much too short the cladding is on the wall. You can fit the
cladding to the wall in following ways:
- Move the first or/and the last board. Type the offset in the
field Move first board or/and Move last board.
- Change the overlap in either of the following ways:
- Select the radio button Cladding fitting by spreading -
The number of boards remains the same and the overlap is reduced to
the value displayed in the Overlap field.
- Select the radio button Fitting by two boards - Two
boards are added to the cladding and the overlap is increased to
the value displayed in the Overlap field.
- Select the radio button No fitting - The number of
boards and the overlap remain the same, in which case the cladding
stays short.
Adding a
Staggered Cladding