Select the Walls

You can select the walls for panel design in the following ways:

• One by one - Select the walls one by one by clicking them. Hold down the Ctrl key.
• All - You can select all walls of a certain type (exterior/interior) at once as follows:
  1. Select one wall in the floor plan or model.
  2. Press Ctrl+A. All walls of the same type will be selected.

• All - If you wish to select both exterior and interior walls at the same time, do as follows:
  1. Select one exterior wall.
  2. Hold down the Ctrl key and select one interior wall.
  3. Press Ctrl+A. All the exterior and interior walls will be selected.

• Area selection - Lock the object type Walls, Exterior and/or Walls, Interior, and select the walls by limiting an area.

Note

• When you are adding panel breaks, the selection method of walls affects the numbering of panels. See Wall Panel Numbering.

Select an Object
Quick Lock an Object Type
Select All Objects of the Same Type
Lock an Object Type
Select an Object with the Cursor
Select Objects within an Area
Select Objects Intersecting an Area