Adding a Support Symbol
This function can be used to add a truss support symbol to a 2D
drawing or 3D model. Before adding a support symbol, you must
display the support marks of the truss by using the Show Supports function. You can create a
support based on the support symbol by using Defining Supports function.
- If necessary, display the support marks of the truss by
selecting the Trusses > Advanced > Show Supports function.
- Select Trusses > Advanced > Add Support Symbol.
- Select the truss.
- Rotate the support symbol or change its size factor or
reference point, if necessary.
- Select the location of the support symbol.
Note
- You can also add a support symbol to the truss envelope
drawing. Open the truss envelope drawing using the Editing a Truss in a 2D Drawing function,
and then select the Adding support symbol function and follow steps
3 and 4. After closing the truss envelope drawing, the support
symbols added will also be displayed in the project's 2D drawing
and 3D model.
Advanced Truss Functions