Regenerating Sheathing

You can edit the positioning of studs in a wall panel drawing by adding, moving or deleting studs. If the sheathing of the wall panel no longer matches the positioning of the studs, you can regenerate the sheathing by clicking Classic Wall Panels > Panel Elevations > Regenerate Sheathing.

The panel section views and the pieces and sheet lists are refreshed when you save the panel drawing.

Note

• The lines of the interior sheathing are drawn on layer 155 and the lines of the exterior sheathing on layer 156.

Regenerating Sheathing
Saving a Panel Elevation without Closing
Closing and Saving a Panel Elevation
Panel Elevations