Adding a Joist from the Profile Library Using One Point

The program will add a joist selected from the profile library that is parallel to the framing and the same length as the framing area. When you select a joist from the profile library, you will add it as described in the section describing profile functions - see Adding a Beam. However, the parameters of a beam added as a joist are different from one added as a profile. You do not type a vertical position for a joist, but its position is tied to the top or bottom surface of the framing.

1. Select Floor Joists, Roof Rafters > Insert > Add Profile from Library.
2. Select the area.
3. Select the profile properties by using the functions on the contextual toolbar:
   • Properties - Define the profile properties in a dialog box.
   • Copying Properties from Another Profile - Copy the properties of a profile added earlier.

   The cross section you selected will be set as the default until you select another cross section.

4. Select the reference point for the cross section.
5. Select the parameters by using the Parameters function.
6. Select the location of the joist's center line.
7. Select Confirm.

Adding a Single Joist