Layer by clicking

When you have selected the detailed representation of the structure with the function Expanding Layers, you can select the layer to be edited by clicking it in the 3D model.

1. Activate the 3D model window.
2. Select Layer by clicking from the contextual toolbar.
3. Select the horizontal structure.
   • Select several structures by holding down the Ctrl key or by using area selection.
   • Select all the horizontal structures by pressing Ctrl+A.
4. Select Confirm.
5. Continue the editing function.

Note

• When editing the edge line or edge points of a single structure you can use the switch One area on the contextual toolbar. In this case, the function procedure is the following:
  1. Activate the 3D model window.
  2. Switch on One area on the contextual toolbar.
  3. Select Layer by clicking from the contextual toolbar.
  4. Select the horizontal structure.
  5. Continue the editing function.

Selecting Structural Layers
Selecting Structure for Edge Editing