Selecting structure for edge editing

When you edit the edge line or edge points of a horizontal structure, you can select one or many structures by using the switch on the contextual toolbar.

Selecting one area

When the switch is in use, you can easily edit a single structure. The structure you click becomes selected at once. After this, you can select a structural layer, if necessary, or continue to the next step of the editing function.

Selecting several areas

When the switch is not in use, you can select several structures in the following ways:

• Click the structures and hold down Ctrl key.
• Select the structures by cropping an area.
• Select all structures by pressing Ctrl+A. If necessary, use the Selection Filter to limit the structures to be selected.

Confirm the selections with the Confirm function. After this, you can select a structural layer, if necessary, or continue to the next step of the editing function.

Selection Filter