All layers

Select all layers of the structure to be edited. The function is selected to be in use by default.

1. Select All layers from the contextual toolbar.
2. Select the structure.
   • Select several structures by holding down the Ctrl key or by cropping an area.
   • Select all structures by pressing Ctrl+A.
3. Select the Confirm function.
4. Continue with the editing function.

Note

• When editing the edge line or edge points of a single structure you can use the switch One area on the contextual toolbar. In this case, the procedure is as follows:
  1. Switch on the function One area on the contextual toolbar.
  2. Select All layers from the contextual toolbar.
  3. Select the structure.
  4. Continue with the editing function.

Selecting structural layer
Selecting structure for edge editing