Reflecting Stair Geometry on Another Floor
You can add stair geometry to the floor panel of another floor
by reflecting the stair's 2D geometry. The stair will remain
unchanged in the model.
- Select General Object Functions >
Reflect Object.
- Select the stair.
- Select Confirm.
- Select the floor on which you want to reflect the geometry.
Select several floors with the Ctrl key pressed down. You will
receive the prompt: "Leave this drawing-model pair active?" The
question refers to the drawing-model pair to which you are
reflecting the geometry.
- Do either of the following:
- If you want to work in the drawing-model pair on which you are
reflecting the geometry, select Yes.
- If you want to work in the drawing-model pair from where you
selected the elements, select No.
Note
- When reflecting a stair created with the Stair Generator on
another floor, the arrow indicating the direction of the stairs
points in the opposite direction from the original geometry if the
Reflection is mirrored property has been selected for the
stair. See Stair Type Parameters.
Designing a Stair
with the Stair Tool And Adding it to a Drawing
Adding Basic
Stairs