Edit Slope

Edit the properties of the slope in the dialog box.

The other values are updated automatically when you change any of the values in the dialog box.

Dialog Box Options

Start elevation (fixed)

The beginning of the pipe, the start elevation, is indicated with a red mark in the model

The end of the pipe line is connected to the start elevation. The value cannot be edited.

End elevation

The end of the pipe, the end elevation, is indicated with a green mark in the model. You can edit the value and view it with the Apply button.

Angle (in degrees)

Enter the angle value in degrees. If the angle tolerance is exceeded, the edit will not be made.

Set Connection Tolerance for Parts

Ratio

Set the slope as a ratio. The following separators are available: colon (:), slash (/) or comma (,).

Apply

Preview the changes you have made to dialog box fields.

Indicate

You can indicate the end elevation in the model. Click the point.

Dir

The program attempts to define the direction to match the assumed flow direction. The direction is top down. You can reverse the direction by clicking the Direction button.

You can enter the angle or ration as a negative value if you wish to maintain the position of a specific pipe end when editing a branch.

Edit Slope