Ladder

Ladders are always added between two studs. Locate the ladder macro at the location of a cabinet, for example. When you generate pieces to a panel, the program adds the extra ladders at even intervals in vertical direction between the nearest studs. Select the parameters of the extra ladders in a dialog box.

Dialog Box Options

Width

You can select a cross section from the profile library by clicking the Select button.

Length

Type the length (L) of the macro in the field. When you generate the pieces to the panel, the extra ladders are added at the location of the macro between the nearest studs. If necessary, ladders are added to more than one stud space.

Height

Type the locating heights of the ladders in relation to the floor base height (ZMASTER) in the field. Type the heights measured to the center lines of the profiles. Separate the heights with commas, for example: 600,1200,1800.

Side

Select either of the following as the location of the extra ladders:

• Int - The ladder backers are positioned on the inner surface of the frame.

• Ext - The ladder backers are positioned on the outer surface of the frame.

Wall Panel Macros