Adding Extra Studs under Trusses
You can add extra studs in the wall panels under the trusses.
The extra studs are parametric panel macros. Before using the
function, generate both the trusses and the panel breaks. The
program will automatically add the panel macros to the floor plan
drawing at the trusses. This requires that the wall has been
selected as a supporting structure when the truss area was
added.
- Select Wall Panels > Panel Settings >
Add Studs Under Trusses.
- Select the wall panels. Select the panels on the walls that
have been selected as supporting structures when the truss area was
added.
- Select Confirm. The Extra Stud Properties dialog box
opens.
- Select the number, positioning and cross section of the studs
in the dialog box.
- Number of studs - Select from the list.
- Location - The parameter is relevant if the size of the
extra stud differs from the frame stud size. Select one of the
following:
- Int - The extra stud is positioned on the inner surface
(A) of the frame.
- Mid - The extra stud is positioned in the middle (B) of
the frame.
- Ext - The extra stud is positioned on the outer surface
(C) of the frame.
- Section - Cross section dimensions of the extra stud.
Select the cross section from the profile library by clicking the
Sel button.
Piece
Properties
- Create sub assembly - When this checkbox is selected,
the extra studs form a sub-assembly. In this case, the assembly
label will be displayed in the stud properties of each stud. If you
wish to add the studs as individual studs without assembly data,
clear the checkbox.
- Confirm by clicking OK.
- If you have already generated parts for the panels, you will be
prompted: "Regenerate parts?" Select either of the following:
- Yes - The program immediately regenerates the
parts.
- No - The program does not regenerate the parts. You can
regenerate the parts later using the Generate Parts
function.
Note
- The macros are visible on the layer 121 Beam Pocket Symbols in
the floor plan.
- The program will not generate parts if the extra stud is
located at an opening.
- You can relocate the panel macro by dragging the grip point
before generating the parts.
- You can also add panel macros to the floor plan drawing by
selecting their locations. Add these extra studs to the floor plan
drawing before generating the panel breaks.
Extra
Studs
Add a Truss Area and
Truss Volumes
Wall Panels in a Framing
Model
Classic Wall Panels