Truss Location

Trusses are added to the truss area with even intervals. From the contextual toolbar, you can select the location method, which will determine the point from which the positioning of the trusses will be started.

From left to right

When this function is used, the positioning of the trusses in the truss area will be started from the left edge of the area. The trusses will be placed according to the interval determined in the parameters. If the trusses are not spread evenly, the distance between the two last trusses on the right will be left shorter than the interval.

From right to left

When this function is used, the positioning of the trusses in the truss area will be started from the right edge of the area. The trusses will be placed according to the interval determined in the parameters. If the trusses are not spread evenly, the distance between the two last trusses on the left will be left shorter than the interval.

From both ends to the center

When this function is used, the positioning of the trusses in the truss area will be started from both edges of the area. The trusses will be placed according to the interval determined in the parameters. If the trusses are not spread evenly, the distance between the two trusses in the middle will be left shorter than the interval.

From a selected point in both directions

When this function is used, the positioning of the trusses in the truss area will be started from the point selected. The trusses will be placed according to the interval determined in the parameters, in both directions from the point selected. If the trusses are not spread evenly, the distance between the two trusses in each end will be left shorter than the interval.

Center point of the interval in the point selected

When this function is used, the positioning of the trusses in the truss area will be started from the point selected, so that the center point of the interval determined in the parameters will be set in that point. The trusses will be placed according to the interval, in both directions from the point selected. If the trusses are not spread evenly, the distance between the two trusses in each end will be left shorter than the interval.

Adding Common Trusses
Adding Valley Trusses