Ridge Joint
Add the joint in the model window.
a = Stiffener
b = Fish plate
c = Height of the fish plate's bottom edge
- Select Floor Joists, Roof Rafters >
Framing
Accessories. The browser is opened.
- Select the Roof Accessories folder in the browser.
- Select Ridge Joint.
- Select the parameters in the dialog box:
- Stiffener amount on one side (PCS) - The same number of
stiffeners are placed on both sides of the web.
- Stiffener thickness (T)
- Stiffener width (W)
- Fish plate code - Select a cross section for the fish
plate from the profile library by clicking the Select
button.
Piece
Properties
- Fish plate library
- Confirm by clicking OK.
- Select the profile ends. Select the ends one by one or use area
selection.
- Select Confirm.
- Define the height of the ridge joint board's bottom edge. Click
the point in the model.
Note
Delete a
Panel
Framing Accessories