Scarf Cut

Select Beams, Columns > Connection Details.
Select the folder Notch / Free in the browser.
Select Scarf cut.
Select the parameters in the Scarf Cut dialog box:
- Heel Height (h)
- Select either of the following variables and type its value in the text field:
  - Length (L)
  - Slope (a)
Confirm by clicking OK.
Select the ends of the beams. Select the beam ends one by one or use area selection.
Select Confirm. The direction of the arrow points the direction of the cut. By default, the direction is the same on all beams.
If necessary, change the direction of the cut in one of the following ways:
- Turn the arrow of a single beam 90 degrees by clicking it. Click the arrow again to turn it 90 degrees, etc.
- Turn all the arrows 90 degrees by clicking the button on the contextual toolbar. Click the button again to turn the arrows 90 degrees, etc.
Select Confirm.