Select Height

With this function, the height of the corner trim is defined by selecting the start and end point of the trim in the model of the building. The cursor or the generic snap point functions are used to select the points.

1. Select the start height of the corner trim.
2. Select the end height of the corner trim.

Note

• The height of the corner trim defined with this function will retain in the program memory until new height is defined or the function is quitted. Corner trims of the same height can thus be added to the next corner directly with the Confirm function.
• The function can be used to add corner trims of same height as the wall height by selecting the Confirm function right after selecting the function, without selecting the end points of the corner trim.

Add Corner Trims to a Single Corner
Add Corner Trims to All Corners
Default Height
Stretch Corner Trims to Roof