Clip an Area and Turn Horizontal
You can clip an area from a sloping horizontal structure with a
polyline and turn the clipped area horizontal.
- Select Floors and Ceilings > Clip
and Turn Horizontal.
- Select the method of selecting the structural layer from the
context-sensitive toolbar.
Selecting a Layer
-
Select the horizontal structure or structural
layer according to the selection mode.
- Click the clipping polyline (A).
- Select Confirm.
- If you clicked a clipping polyline in the middle of the
structure, select either of the following:
- Lowest Edge - The bottom edge of the area to be clipped
will remain in place.
- Highest Edge - The top edge of the area to be clipped
will remain in place.
Advanced
Floor and Ceiling Functions