Add a Hole by Lines
You can add a hole to a horizontal structure. The hole can go
through the entire structure or it can be added only to the
selected structural layer. The same hole can cut several horizontal
structures located side by side.
- Select Floors and Ceilings > Create
Hole Using Lines.
- Select the method of selecting the structural layer from the
context-sensitive toolbar.
Selecting a
Layer
- Select the horizontal structure or structural layer according
to the selection mode.
- In the case of a sloping structure, select, if the points are
to be projected to the top or bottom surface of the structure.
- Measure height to top - The edge points
are projected to the top surface of the structure.
- Measure height to bottom - The edge points
are projected to the bottom surface of the structure.
- In the case of a sloping structure, select perpendicular or
vertical edges to the hole.
- Perpendicular edge - The edge direction is
perpendicular to the structure.
- Vertical edge - The edges are
vertical.
- Select lines or a line chain. The lines can be single lines or
they can form a closed polyline. The edge lines can reach outside
the structure and run across several horizontal structures.
- Select Confirm.
Note
- You can delete a hole from the structure by deleting its edge
points.
Add a Hole Using
Points
Delete an Edge Point
Floors and Ceilings