Continue selecting the wall points
- Select Lock cursor vertically from the contextual
toolbar. The cursor is locked in the y axis direction.
- Click the next point (2) approximately as shown in the figure.
The exact location of the point is insignificant. However, follow
the coordinates at the right end of the status bar:
When dy is about 8000, click the point.
After you have clicked the point, the cursor is
automatically locked in the x axis direction.
- Click the next point (3) approximately as shown in the figure.
After you have clicked the point, the cursor is automatically
locked in the y axis direction.
- Click the other points 4..9 marked in the figure in the same
way. Click the points so that the floor plan looks approximately
like in the figure.
Tip: You can cancel the last clicked point by pressing
Ctrl+Z.