Select the reference line and the first point
- Select the wall center line as the reference line. Click the
button
Placement: Wall middle on the contextual toolbar.
The status bar of the program window displays the following prompt:
In the middle of the status bar you can see the properties of the selected wall:
- Select the first point (1). Begin adding the wall from the
drawing's origin, which has been marked with a green cross. Move
the cursor near the point, and click the left mouse button.
Note: Move the cursor close enough the point, so that the cursor appears as in the above figure. The circle (
) at the
bottom right corner of the cursor indicates that you can select the
point by clicking the left mouse button.
