Piping Design |
The positioning method is one of the following when adding a pipe/duct line or pipe/duct component in the model window:
Position to grip point
The grip point is located at the end of the center line. Select any of the snap functions:
Snap to point
Snap to line and point
Snap to all geometry
Move the cursor near the grip point. Note the cursor's snap to the grip point:
If necessary, zoom the model to see the grip point. Select the grip point.
Positioning to center line
Select either of the following snap functions:
Snap to line and point
Snap to all geometry
Move the cursor over the center line. Select the center line.
Position to face
You can position a component by its grip point to a face you select from the geometry surrounding the component. Select the snap function:
Snap to all geometry
Select the face.
Auxiliary
Functions when Adding a Pipe or Duct Line
Auxiliary Functions when Adding a
Pipe or Duct Component
Converted from CHM to HTML with chm2web Pro 2.85 (unicode) |