Add a Machining
When you open the log work drawing of a wall for the first time,
the program will automatically add the machinings defined in the
machining library. If necessary, you can add individual machinings
to the log work drawing. Use the function when the log work drawing
is open. Select a machining from the machining library.
- Open the log work drawing.
- Right-click to open the context-sensitive menu.
- Select Add Machining.
- Select a machining from the list. The list consists of the
machinings in the machining library.
- The following steps depend on the machining selected. Follow
the prompts displayed on the status bar.
- If, for example, you selected a pin or dowel, perform the
following phases:
- Select the start point. You do not need to constrain the
cursor, because the program will automatically add the machining
either vertically or horizontally (depending on the
machining).
- Select the end point.
- If, for example, you selected a cribbing, perform the following
steps:
- Select the logs. Select several logs with the Ctrl key
down.
- Select Confirm.
- Select a location for the machining.
Note
Open a Log Face
Drawing
Edit a Machining
Change a Machining
Loghouse Setup File
Keywords Connected with Machinings
Log House Work Drawings