Adding Backer Macros
When automatically generating the panel breaks using the
Generate Panel Breaks function,
you can choose to add backers at panel joints. You can add backers
to the floor plan drawing even after generating the panel
breaks.
- Select Classic Wall Panels > Panel Layout
> Add Backers at Wall Intersections.
- Confirm adding backers to T joints of panels by clicking
Yes in a message box. The program will add backer macros at
all T joints on the floor plan drawing.
- The next message box prompts you to select whether you wish to
replace existing backers if there are any on the floor plan
drawing.
- By clicking No in the message box, you can add backers
only where there are not yet any backers.
- By clicking Yes, you can remove all existing backers and
add them again. If there are no existing backers, it does not
matter which option you select.
Note
- The backer detail (its cross section size and location) is
defined in the project parameters.
Panel
Layout