Adding a profile
You can add a piece to an open panel drawing. The available
cross sections are customer-specific. You can position the piece in
the front projection of the panel by selecting the location of the
reference point at its start and end. The reference point can be a
different point at each end of the piece.
- Select Wall
Panels > Panel Elevations > Add
Profile.
- Select the cross section of the piece in a separate drawing
window by clicking the hot spot.
- Select the reference point combination from the contextual
toolbar.
- Select the start point.
- Select the end point.
- Select the Confirm function.
- When adding a vertical stud, you can cut the sheathing at the
stud by clicking Yes in the message box. If you cut the
sheathing, the program will indicate that both the exterior and
interior sheathing is cut at the center of the piece.
Note
- The section view and the pieces and sheet lists of the panel
drawing will be refreshed when you save the panel drawing using the
Saving panel drawing
function.
Panel
Elevations