Freeze Part Numbers
When editing the parts of a panel and updating the panel
drawing, the part labels can always be recreated. You can prevent
this by using the part number freezing function. This function
strives to maintain the existing part numbers as unchanged as
possible. It is primarily intended to be used in situations where
the production has already begun while the design is still in
progress.
Only applicable to profiles.
- Select Panels > Freeze Part
Numbers.
- Select the panels.
- Select Confirm.
Once the part numbers have been frozen, you can edit the part
numbers in the panel by editing the part label properties:
- Open the panel drawing.
- Select a part label.
- Right-click to open the context-sensitive menu.
- Select Properties.
- Edit the label in the dialog box.
- Confirm by clicking OK.
Note
- When you edit the part number in the panel drawing, the change
applies to all parts in the drawing that have the same label.
- If the project-specific part numbering system is enabled
(identical parts in separate panels are assigned the same part
number) and you edit the part number in the panel drawing, the
change will also apply to other panels' parts that carry the same
label. The user will be warned in situations where the change will
affect panels that do not have frozen part numbering. The numbering
system used depends on the customer-specific customization.
Release
Part Numbers
Floor and Roof Panels
Wall
Panels