Renumber Panels
You can renumber panels as follows:
- Select Panels > Change
Label. You can use the function to edit panel labels in two
ways:
- Renumber Panels - This is the default method. The status
bar displays the following prompt: "Renumbering Panels (number):
Select a panel (1)."
- Change the label prefix - The status bar displays the
following prompt: "Renumbering Panels (prefix): Select a
panel."
- Check the renumbering mode in the status bar prompt.
If necessary, switch the renumbering mode using
the Switch renumbering mode function in the
contextual toolbar until the prompt reads as follows: "Renumbering
Panels (number): Select a panel (1)."
- Select the first panel.
- Press and hold the Ctrl key to select the other panels. Select
the panels in numerical order from smallest to largest.
- Select Confirm. The Panel Numbering dialog box
opens.
- In the dialog box, type the number you want to start the panel
numbering from.
- Confirm by clicking OK.
When renumbering the selected panels, the
program will assign the starting number to the panel selected
first, after which the starting number is increased by one. The
panel prefixes will remain unchanged.
Note
- If any of the numbers is already in use, the program will
display an error message and the renumbering will not be
performed.
Change the
Label Prefix
Floor and Roof Panels