Trimming the End of a Wall Volume to the Side of Another
You can trim the end of a wall volume to the side of another
wall volume.
- Select Walls > Trim
Wall Volume.
- Select the target volume to which trimming is to be
performed.
- Select the volume to be shaped by stretching or
shortening.
- Select either of the following as the side of the target
volume:
- Near - Trimming to the nearest side of the target
volume.
- Far - Trimming to the furthest side of the target
volume.
Note
- An actual connection between the wall volumes is not created.
Therefore, the shaping will not follow when the model is changed
otherwise.
Trimming Wall
Volumes to Corner
Walls