Adding an eave return

You can add an eave return on the gable end of the roof.

1. Select Roofs > Add Eave Return.
2. Select the slope.
   
3. Select the corner.
   
4. Select the length. The cursor is locked to move along the slope. You can type the length in the Coordinates Input dialog box, or use the snap functions. The Coordinates Input dialog box opens, when you press a number key on the keyboard.
   
5. Select the width. The cursor is locked to move along the roof ridge. You can type the width in the Coordinates Input dialog box, or use the snap functions. The Coordinates Input dialog box opens, when you press a number key on the keyboard.
   
6. Select the eave return parameters in the Eyebrow dialog box.
   • Main slope
     • Offset - The distance between the edge of the eyebrow and the gable eave (D). Select the offset from the list or type any value in the text field.
     • Length - The length of the eyebrow (L). Edit the value, if necessary.
     • Pitch - Select from the list or type a ratio (for example 1/3) or decimal (for example 0.33) in the text field.
       
   • Side slope - Select the check box, when you want to add a side slope to the eyebrow.
     • Pitch - Select from the list or type a ratio (for example 1/3) or decimal (for example 0.33) in the text field.
       
7. Click OK.

Note

• If the program is not able to model the eave return with the parameters you have selected, you will be prompted: "Eyebrow is too short. Length is expanded."
• If necessary, edit the joint of the eave return and the roof by using the function Trimming area edges.

Roofs