Set a Fixed Point for the Building Component Library Swap
You can select a fixed point from a building component when
replacing the component with a component in a different library.
That point will remain in the same place. The fixed point matters
when the original and the new component are of different sizes.
- Select
Building Components > Advanced > Set
Fixed Point for Macro Library Swap.
- Select a component.
- Select any point in the component as the fixed point.
Note
- A fixed point selected for a window or a door will also
determine the unmoving point when you resize the opening by editing
its properties.
- If you do not select a fixed point, the program will use the
locating point last used as the fixed point when the location of
the original component was defined.
Swap Component
Library
Advanced Functions for Building
Components