Select Constraints. The Constraints of Object dialog box
opens. Following constraints have been automatically created for
the wall:
Corner connection - Two corner joints to the connected
walls. Also side joints (T connections) are automatically created
when you add walls.
Position fixed - The constraint is created for the walls
(A) and (B) connected to the origin. The constraint was created
since you used the wall center line as the reference line (CENTER),
and started adding walls from the origin point. Other walls do not
have this constraint. When you later edit the floor plan by
defining Dimension constraints, the walls (A) and (B) will always
remain in place while the other walls move.
Direction fixed - The constraint was created since you
locked the cursor to horizontal/vertical direction.
Height levels - The top edge of the wall is
automatically constrained to the height level CEILING-X and the
locating height to the level FLOOR-X.